Bring your meters
Modbus, BACnet and MQTT through a small gateway, or readings from your existing BMS via API.
Energy & Sensors · Basement
Meters and sensors that raise their own work orders.
Connect energy meters, tank level sensors, temperature probes and DG controllers, or enter readings by hand during rounds. Set limits once. When a reading crosses a limit, the right team gets a job, not a dashboard alert nobody reads.
Basement
Building load612 kW
Overhead tank T152%
Server room23.4 °C
DG Set 1 fuel62%
Tank T1 level, todayLow limit 25%
11:05 level hit 24%. WO-2468 raised to plumbing, pump P2 started.
How it works
- 01Connect
Gateway or BMS link, or start with manual readings.
- 02Set limits
High, low and rate-of-change limits per sensor.
- 03React
Breaches raise work orders to the right team.
- 04Report
Daily and monthly consumption by floor and tenant.
What it does
Built for the way energy & sensors really run.
Manual readings count too
No sensors yet? Technicians log meter and tank readings on their rounds and the same limits apply.
Limits that create jobs
Overhead tank below 25 percent, server room above 26 °C, DG fuel below 40 percent. Each raises a ticket.
Energy by floor and tenant
Sub-meter consumption split by floor, common area and tenant for monthly recharge.
DG and fuel
Running hours, fuel level, load test history and fuel top-up logs in one place.
Water balance
Fresh water, recycled water and STP output tracked against daily consumption.
Specification sheet
The details your engineers will ask about.
Everything listed is included in the plans that carry Energy & Sensors. See Plans for what each plan covers.
- Protocols
- Modbus RTU and TCP, BACnet IP, MQTT, REST API
- Sensor types
- Energy, water flow, tank level, temperature, humidity, DG
- Reading interval
- From 1 minute for sensors, per round for manual
- Limits
- High, low, rate of change, no-data timeout
- Recharge
- Tenant sub-meter reports in CSV and PDF
- Retention
- Raw readings for 13 months, daily totals kept for the contract
Questions
Energy & Sensors: common questions
Do we need sensors to start?
No. Everything else works without them, and manual readings during rounds use the same limits and alerts.
Can it read from our BMS?
Yes, through the API or a gateway reading BACnet or Modbus points that your BMS already exposes.
Who installs the gateway?
Your electrical or BMS vendor, using our point list. Setup is usually under a day per building.
Key register · Handover
Take the keys to one building.
Bring your asset list and your floor plan. Within a day your QR tags are printed, your PPM calendar is built and your team is raising jobs. Run it free for 30 days.
- Trial
- 30 days, one building
- Setup
- Usually one working day
- Card
- Not needed to start